Do It Yourself Pool

The process involving a DIY pool project

The first step is to select the site for the pool and set the elevation so that the top of the pool will be 6 to 12feet above the existing ground at the highest part of your concrete apron. You may need to hire a sub-contractor to help you dig the hold and this may cost you anywhere between $275-$650 and take 7-10 hours, depending on the depth required.
Next, the walls need to be assembled and these go together easily, on a ledge that is dug over around the pool. You may need to attach the coping around the top with the self-tapping screws included and this coping has a receptor slot that holds the pool liner in, doubling up its act to be a form for pouring the concrete apron.

Tips to ensure a sound base for your pool

The footing needs to be poured in around the outside of the wall and this secures things in place, being anywhere between 8 to 10 inches thick and 2' wide and offering no further adjustment in the walls after being poured. The plumbing follows this and the plans usually provide this with the pool equipment. You may just be required to get 1 ’Ä°" Schedule 40 PVC pipe and fittings. This PVC can be cut with a hacksaw and glued and plumbed successfully by even a novice in a couple hours. Putting in the bottom of the pool may need you to hire a subcontractor again for the mixing and installation of the sand & port land bottom since these are not designed to hold up the weight of the water, but will separate the dirt from the liner and give the liner a good smooth uniform fit. You may ask around for help to hang the liner and cut the face plates as more hands will mean less and quicker work; the liner snaps in the coping and fits the dimensions of the pool. After this, a wet-dry shop vacuum can be used to suck the air out from behind the liner and draw it snugly into place and the pool is ready to start adding water.

Finishing touches to the do it yourself pool

You can backfill the pool and take help from a contractor to finish the concrete apron, which may take half a day and clean the pool up using the chemicals provided, according to the manufacturer's instruction. Choose a branded manufacturer as they give best warranties and high quality service too, so it is indeed the coolest offer in the long run.

There are many more fixture articles in our fixture section. There is more specific information in the links at the beginning of this article. They can guide you where you need to go.